Cardinal 205 Installation And Technical Manual page 29

SETUP AND CALIBRATION, CONT.
Single-Point for Zero Only (Only Zero) Calibration
IMPORTANT! The functions of numeric keys are replaced by using the
UNITS/
LEFT ARROW
identified by the blinking character and can be advanced to the left to the next
position by pressing the UNITS/
key will change the blinking character to the next value.
ARROW
! > – First Calibration Weight
The display will show ! > . This is the first of two calibration steps.
Insure the scale is empty.
Press the TARE/
ENTER
Starting at the left and proceeding right, a series of dashes will appear on the display.
The dashes will stay on the display momentarily, then disappear, after which the
display will show: !>.
!> - Second Calibration Weight
The display will show !> . This is the second of two calibration steps.
Press the ZERO key.
The display will advance to *-6.
Calibration "" Numbers
1. With ! > displayed, press the TARE/
2. At the  > prompt, press the TARE/
3. If the  > number displayed is acceptable, press the TARE/
4. Otherwise, use the ASTERISK/
 > number, then press the TARE/
5. Repeat steps 2 through 4 for >, > and >.
NOTE! If any components have been changed that affect calibration and/or
your scale is used in a commercial application and must be "Legal for Trade"
you cannot use the "" numbers to re-calibrate.
8200-M024-O1 Rev G y 205 Installation & Technical
and the ASTERISK/
UP ARROW
LEFT ARROW
key.
key (with diamond "T" symbol).
ENTER
key to show the current value of the  number.
ENTER
and UNITS/
UP ARROW
key.
ENTER
keys. The cursor location is
key. Pressing the ASTERISK/
key again to save it.
ENTER
keys to enter a new
LEFT ARROW
UP
25