Installing and Removing XENPAK Modules (Catalyst 3750G-16TD Switch)
Removing a XENPAK Module
To remove a XENPAK module, follow these steps:
Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface on the chassis.
Step 1
Disconnect the cable from the XENPAK module. For fiber-optic modules, install the optical bore dust
Step 2
plugs.
Loosen the two captive installation screws that secure the XENPAK module in the slot.
Step 3
Carefully pull on the two captive installation screws to disconnect the XENPAK module from the slot.
Step 4
Grasp the edges of the XENPAK module, and carefully slide it out of the slot, as shown in
Step 5
Figure 2-53
1
Use two Phillips-head screws to attach the XENPAK module slot cover to the switch front panel, as
Step 6
shown in
Warning
Blank faceplates (filler panels) serve three important functions: they prevent exposure to hazardous
voltages and currents inside the chassis; they contain electromagnetic interference (EMI) that might
disrupt other equipment; and they direct the flow of cooling air through the chassis. Do not operate
the system unless all cards and faceplates are in place. Statement 156
Catalyst 3750 Switch Hardware Installation Guide
2-38
Removing a XENPAK Module
T X
R X
1
2
Optical bore dust plug
2
Figure
2-54.
1
Captive installation screw
Chapter 2
Switch Installation
Figure
C a ta ly s t 3
7 5 0
s e ri e s
OL-6336-10
2-53.