Internal Temperature Cli Commands - Digi Connect Sensor User Manual

Hide thumbs Also See for Connect Sensor:
Table of Contents

Advertisement

Internal temperature CLI commands

Use the following command with the set command when configuring the device with the CLI.
CAUTION! If Connect Sensor sends reports less than 15 minutes apart, it may result in an internal temperature that is above the ambient
temperature.
CLI
Option
commands Description
Internal
ena
Enables or disables the internal temperature sensor.
temperature
interface
Enables or disables alarm reports for the internal
Alarms
aem
temperature. When enabled, sends an alarm report in
one of the following conditions:
n
n
High
alh
Specifies the internal temperature in degrees Celsius
threshold
that generates a high alarm report when the high alarm
is enabled.
Low
all
Specifies the internal temperature in degrees Celsius
threshold
that generates a low alarm report when the low alarm is
enabled.
High alarm
Low alarm
Value options
on
n
off
n
hi
n
lo
n
Enable multiple alarms using a comma
n
separated command without spaces
(such as set ain1 aem=hi,lo)
-100 to 100
-100 to 100
Default
off
Empty
(all
disabled)
50.0
0

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Connect Sensor and is the answer not in the manual?

Questions and answers

Table of Contents