Digital Pulse Counter Cli Commands - Digi Connect Sensor User Manual

Digital pulse counter CLI commands

Use the commands in the following table with the set command and pcnt1 when configuring the digital pulse counter options with the CLI. For example,
type set pcnt1 ena=on to configure the digital pulse counter interface.
CLI
Option command Description
Digital pulse ena Enables or disables the digital input source.
counter
interface
Enables or disables alarm reports for the digital
Alarms aem
pulse counter source. When enabled, sends an
alarm report in one of the following conditions:
Specifies the high threshold in number of pulses
High threshold alh
that generates a high alarm report when high
alarm is On.
Specifies the low threshold in number of pulses
Low threshold all
that generates a low alarm report when low
alarm is On.
Specifies when to keep an alarm on or shut off an
Hysteresis ahy
alarm during high and low alarm states.
High alarm
n
Low alarm
n
0 — hysteresis is off
n
1 or more — hysteresis is on and
n
managing alarms
Value options
on
n
off
n
hi
n
lo
n
Enable both alarms using a
n
comma separated command
without spaces
(such as set pcnt1 aem=hi,lo)
Number
Number
Number
Default
off
Empty (all alarms
disabled)
0
0
0