Atex Marking - Digi Connect Sensor User Manual

About Digi Connect® Sensor
WARNING! The Connect Sensor unit should not be installed in locations with either
pressurized or flammable materials. The battery should be replaced in unclassified areas
only.
WARNING! Install Connect Sensor in an area that does not have more than pollution
degree 2 as defined in EN/ IEC 60664-1.
WARNING! To avoid potentially dangerous electrostatic discharges, control all likely
ignition sources, minimize the harmful effects of any accidental fire or explosion by using
explosion relief and suppression systems. All zoned areas containing potentially
explosive atmospheres should be clearly marked using ATEX Ex hazardous area warning
signs.
WARNING! Potential electrostatic charging hazard. To avoid building up an electrostatic
charge when cleaning the enclosure of this device, you must use a damp cloth moistened
only with water. Do not use flammable cleaning agents.

ATEX marking

The device must include the markings described in the following table.
Mark
Digi Connect® Sensor User Guide
Description
ATEX logo
Safety notices
16