Installing Prosonic Flow P (Dn 50 To 4000 / 2 To 160") (Clamp On) - Endress+Hauser Proline Prosonic Flow 93T Portable Operating Instructions Manual

Proline Prosonic Flow 93T Portable
2.8 Installing Prosonic Flow P (DN 50 to 4000 / 2 to 160")
(Clamp On)
!
Note!
Sensor orientation shown in the following sketches is for visual purposes only.
Please apply the recommended orientation → ä 6.
2.8.1 Installation for measurement via one traverse
Prerequisites
• The installation distances (sensor distance and wire length) are known → ä 8.
• The strapping bands are already mounted → ä 14/→ ä 15.
Material
The following material is needed for mounting:
• Two strapping bands incl. mounting bolts and centering plates where necessary (already
mounted)
• Two measuring wires, each with a cable lug and a fixer to position the strapping bands
• Two sensor holders
• Coupling fluid for an acoustic connection between the sensor and pipe
• Two sensors incl. connecting cables
Procedure
1. Prepare the two measuring wires:
– Arrange the cable lugs and fixer such that the distance they are apart corresponds to the
wire length (SL).
– Screw the fixer onto the measuring wire.
Fig. 13: Fixer (a) and cable lugs (b) at a distance that corresponds to the wire length (SL)
2. With the first measuring wire:
– Fit the fixer over the mounting bolt of the strapping band that is already securely
mounted.
– Run the measuring wire clockwise around the pipe.
– Fit the cable lug over the mounting bolt of the strapping band that can still be moved.
Endress+Hauser
SL
1 2 3 4 5 6 7 8 9 10 11
Installation
A0001112
19