Commissioning - Endress+Hauser Proline Prosonic Flow 93T Portable Operating Instructions Manual

Proline Prosonic Flow 93T Portable
4

Commissioning

4.1 Switching on the measuring device
The measuring device is switched on by pressing the ON/OFF switch ≥ 3 seconds
(→ ä 26, No. 1).
After being switched on, the measuring system performs a number of internal test functions. As
this procedure progresses the following sequence of messages appears on the onsite display:
Display examples:
PROSONIC FLOW 93
START-UP
RUNNING
PROSONIC FLOW 93
DEVICE SOFTWARE
V XX.XX.XX
CURRENT OUTPUT
...
SYSTEM OK
→ OPERATION
The measuring device starts operating as soon as the startup procedure is complete.
Various measured values and/or status variables appear on the display.
!
Note!
If an error occurs during startup, this is indicated by an error message.
List of all error messages, see associated Operating Instructions on the CD-ROM.
Endress+Hauser
Æ
Æ
Æ
Start-up message
Display of current software
Display of installed input/output modules
Beginning of operation
Commissioning
27