Endress+Hauser Proline Prosonic Flow 93T Portable Operating Instructions Manual page 21

Proline Prosonic Flow 93T Portable
7. Coat the contact surfaces of the sensors with an even layer of coupling fluid
approx. 1 mm (0.04") thick, going from the groove through the center to the opposite
edge.
Fig. 16: Coating the contact surfaces of the sensor with coupling fluid
8. Insert the sensor into the sensor holder.
9. Fit the sensor cover on the sensor holder and turn until:
– The sensor cover engages with a click.
– The arrows (Å / Æ "close") are pointing towards one another.
10. Screw the connecting cable into the individual sensor.
Fig. 17: Mounting the sensor and connecting the connecting cable
This completes the mounting process. The sensors can now be connected to the transmitter via
the connecting cables → ä 25.
Endress+Hauser
Installation
A0011373
A0001115
21