Determining The Installation Distances - Endress+Hauser Proline Prosonic Flow 93T Portable Operating Instructions Manual

Proline Prosonic Flow 93T Portable
2.5

Determining the installation distances

2.5.1 Running the "Sensor Installation" Quick Setup menu
Calling the Quick Setup
All the installation distances required for sensor mounting are determined with the Quick Setup.
!
Note!
If you are not familiar with the operation of the device → ä 28.
F → Enter the function matrix (starting with measured value display)
1.
P → Select the group QUICK SETUP
2.
F → Confirm selection
P → Select the SENSOR INSTALLATION function
3.
F → Confirm selection
4. Intermediate step if configuration is blocked:
P → Enter the code 93 (confirm with F ) and thus enable configuration
P → Go to Sensor Installation Quick Setup
5.
P → Select YES
6.
F → Confirm selection
F → Start Sensor Installation Quick Setup
7.
For subsequent steps, see the following section "Running the Quick Setup for Clamp On type of
mounting".
Endress+Hauser
Installation
9