Lap Timer Reset And Exit; Tire Pressure Monitoring System (Tpms) - If Equipped; Function - Triumph Daytona 675 2014 Owner's Handbook Manual

Lap Timer Reset and Exit

To reset the lap timer and exit lap timer,
press button B for two seconds. After
two seconds, the lap timer will reset and
Lap will be shown in the display screen.
This will delete the stored data for all
stored laps.
To exit the data retrieval mode without
resetting the lap timer, press button A
for two seconds, Lap will be visible in the
display screen. Press
button A to select the desired display.
Tire Pressure Monitoring
System (TPMS) - If Equipped
The daily check of tire pressures must
and release
not be excluded because of the
installation of the TPMS. Check the tire
pressure when the tires are cold and
using an accurate tire pressure gauge
(see page 126).
Use of the TPMS system to set
inflation
incorrect tire pressures leading to loss
of motorcycle control and an accident.

Function

Tire pressure sensors are mounted to
the front and rear wheels. These
sensors measure the air pressure inside
the tire and transmit pressure data to
the instruments. These sensors will not
transmit the data until the motorcycle is
traveling at a speed greater than 12 mph
(20 km/h). Two dashes will be visible in
the display area until the tire pressure
signal is received.
An adhesive label will be mounted on the
wheel rim to indicate the position of the
tire pressure sensor, which is near the
valve.
For motorcycles
pressure monitoring system installed:
The tire pressure monitoring system
(TPMS) is an accessory equipped item
and must be installed by your authorized
Triumph dealer. The TPMS display on the
instruments will only be activated when
the system has been installed.
General Information
Warning
pressures may lead
without the
to
tire
37