Installing The Chassis Intrusion Switch - Dell PowerEdge T300 Series Hardware Owner's Manual

1 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet and from the peripherals.
2 Remove the system cover (see "Removing the System Cover" on page 66).
3 Open the expansion card cover (see Figure 3-7).
4 Disconnect the chassis intrusion switch cable from the INTRUSION
connector on the system board (see Figure 3-30).
5 Slide the chassis intrusion switch out of the securing bracket notch, then
remove the switch and its attached cable from the system.
Figure 3-30. Removing and Installing the Chassis Intrusion Switch
1
1 securing bracket notch
3 INTRUSION connector on system
board

Installing the Chassis Intrusion Switch

1 Align the chassis intrusion switch with the securing bracket notch (see
Figure 3-30).
2 Slide the switch into the securing bracket notch (see Figure 3-30).
2
3
2 chassis intrusion switch
Installing System Components
121