GE D30 Instruction Manual page 667

APPENDIX H
Table H–5: MAJOR UPDATES FOR D30 MANUAL REVISION AA2 (Sheet 2 of 2)
PAGE PAGE CHANGE
(AA1) (AA2)
3-8 3-8 Update
5-23 5-23 Add
5-31 5-31 Add
B- B- Update
H-7 H-7 Update
Table H–6: MAJOR UPDATES FOR D30 MANUAL REVISION AA1
PAGE PAGE CHANGE
(Z1) (AA1)
--- --- Add
2- 2- Update
2- 2- Update
2-15 2-15 Update
6-21 6-21 Add
--- 6-25 Add
8- --- Delete
--- 10- Add
--- D- Add
Table H–7: MAJOR UPDATES FOR D30 MANUAL REVISION Z1
PAGE PAGE CHANGE
(Y3) (Z1)
--- --- Add
--- --- Add
1-1 1-1 Add
1-5 1-5 Update
2-9 2-9 Update
5-24 5-24 Add
5-85 5-85 Update
5-89 5-89 Update
5-223 5-223 Add
Table H–8: MAJOR UPDATES FOR D30 MANUAL REVISION Y3
PAGE PAGE CHANGE
(Y2) (Y3)
-- xi Add
GE Multilin
DESCRIPTION
Updated Figure 3-10 Typical Wiring Diagram to include delta and wye voltage input options
Added Syslog Format section
Added Far-End Fault Indication (FEFI) section
Updated Modbus memory map and F codes
Updated product warranty from 24 months to 10 years
DESCRIPTION
Added content for IEC 60870-5-103 throughout document
Updated order codes
Updated specifications
Updated Phase Distance Operating Time Curve figure and Ground Distance Operating Time
Curve figure
Added Z to Table 6-2 FlexElements Base Units
BASE
Added Distance section for Actual Values > Metering > Distance
Deleted chapter 8 on security, moving content to other chapters
Added Maintenance chapter, moving content from other chapters and adding new instructions to
replace the battery
Added new appendix on IEC 60870-5-103 interoperability
DESCRIPTION
Added CPU options U and V to order code tables in chapter 2, a note above Rear Terminal View
figure in chapter 3, and CPU Module Communications Wiring figure in chapter 3
Added Parallel Redundancy Protocol (PRP) to order code tables and specifications in chapter 2,
section 5.2.5d Settings > Product Setup > Communications > Network, section 6.3.1 Actual
Values > Status > PRP, and Appendix B Modbus table and F627 and F628 enumeration tables
Added General Cautions and Warnings to section 1.1.1
Revised section 1.3.1 on system requirements, including addition of support for Windows 7 and
Windows Server 2008
Updated several specifications
Added section 5.2.5e Routing
Updated Figures 5-24 and 5-25 Dual Breaker Control Scheme Logic, sheets 1 and 2
Updated Figure 5-26 Disconnect Switch Scheme Logic
Reinserted section 5.8.5c Remote Devices: ID of Device for Receiving GSSE/GOOSE Messages,
meaning the Settings > Input/Outputs > Remote Devices settings
DESCRIPTION
Added battery disposal information as chapter 0
D30 Line Distance Protection System
H.1 CHANGE NOTES
H
H-3