GE D30 Instruction Manual page 217

5 SETTINGS
The digital state can be entered locally (by directly pressing the front panel pushbutton) or remotely (via FlexLogic oper-
ands) into FlexLogic equations, protection elements, and control elements. Typical applications include breaker control,
autorecloser blocking, and setting groups changes. The user-programmable pushbuttons are under the control level of
password protection.
The figure shows user-configurable pushbuttons for the enhanced front panel.
Figure 5–13: USER-PROGRAMMABLE PUSHBUTTONS (ENHANCED FRONT PANEL
The following figure shows user-configurable pushbuttons for the standard front panel.
Figure 5–14: USER-PROGRAMMABLE PUSHBUTTONS (STANDARD FRONT PANEL)
Both the standard and enhanced front panel pushbuttons can be custom labeled with a factory-provided template, available
online at http://www.gegridsolutions.com/multilin. The EnerVista software can also be used to create labels for the
enhanced front panel.
Each pushbutton asserts its own "On" and "Off" FlexLogic operands (for example,
). These operands are available for each pushbutton and are used to program specific actions. If any pushbutton is
OFF
active, the operand is asserted.
ANY PB ON
Each pushbutton has an associated LED indicator. By default, this indicator displays the present status of the correspond-
ing pushbutton (on or off). However, each LED indicator can be assigned to any FlexLogic operand through the
setting.
LED CTL
The activation and deactivation of user-programmable pushbuttons depends on whether latched or self-reset mode is pro-
grammed.
• Latched mode: In latched mode, a pushbutton can be set (activated) by asserting the operand assigned to the
setting or by directly pressing the associated front panel pushbutton. The state of each pushbutton is stored
BTN 1 SET
in non-volatile memory and maintained through a loss of control power.
The pushbutton is reset (deactivated) in latched mode by asserting the operand assigned to the
ting or by directly pressing the associated active front panel pushbutton.
It can also be programmed to reset automatically through the
tings. These settings enable the autoreset timer and specify the associated time delay. The autoreset timer can be
used in select-before-operate (SBO) breaker control applications, where the command type (close/open) or breaker
location (feeder number) must be selected prior to command execution. The selection must reset automatically if con-
trol is not executed within a specified time period.
• Self-reset mode: In self-reset mode, a user-programmable pushbutton can be set (activated) by asserting the operand
assigned to the
PUSHBTN 1 SET
time it is pressed plus the dropout time specified in the
via FlexLogic, the pulse duration is specified by the
assigned to the
PUSHBTN 1 SET
GE Multilin
setting or by pressing the front panel pushbutton. A pushbutton remains active for the
PUSHBTN 1 DROP-OUT TIME
PUSHBTN 1 DROP-OUT TIME
setting remains On has no effect on the pulse duration.
D30 Line Distance Protection System
PUSHBUTTON 1 ON
and
PUSHBTN 1 AUTORST PUSHBTN 1 AUTORST DELAY
setting. If the pushbutton is activated
only. The time the operand remains
5.2 PRODUCT SETUP
5
and
PUSHBUTTON 1
PUSHBTN 1
PUSH-
set-
PUSHBTN 1 RESET
set-
5-81