Subaudible Tones - Icom IC-V82 Instruction Manual

■ Tone scan
By monitoring a signal that is being operated with a repeater,
pocket beep or tone squelch function, you can determine the
tone frequency necessary to access a repeater or open the
squelch.
q Set the frequency to be checked for a tone frequency or
code.
w Push [A•
], then push [1•
FUNC
• Repeat several times to select the tone condition or type to be
scanned. (One of " ," " " or " " appears)
• The tone scan can be operated even if the tone condition or type
is not selected.
1
A
Push
FUNC
TONE
e Push [A•
], then push [3•
FUNC
scan.
• To change the scanning direction, push [Y Y ] or [Z Z ].
3
A
Push
FUNC
T.SCAN
].
TONE
D
. ] to start the tone
T SCAN

SUBAUDIBLE TONES

r When the CTCSS tone frequency or DTCS code is
matched, the squelch opens and the tone frequency or
code is temporarily programmed into the selected mode
such as memory or call channel.
• The tone scan pauses when a CTCSS tone frequency or 3-digit
DTCS code is detected.
• The decoded CTCSS tone frequency or 3-digit DTCS code is
used for the tone encoder or tone encoder/decoder depending
on the selected tone condition or type in step w.
- No indication : Cannot be used for operation.
- " " : CTCSS tone encoder
- " " : CTCSS tone encoder/decoder
- " " : DTCS tone encoder/decoder
D
t Push [D•
] to stop the scan.
CLR
9
9
35