Icom IC-V82 Instruction Manual page 45

D Setting subaudible tones for tone squelch operation
Separate tone frequencies can be set for tone squelch oper-
ation rather than repeater operation (the same range of tones
is available— see right below). Like the repeater tones, these
are set in .
SET MODE
q Select VFO or memory channel.
w Push [A•
], then push [8•
FUNC
e Push [Y Y ] or [Z Z ] several times until "Ct" appears when se-
lecting CTCSS, or "dt" appears when selecting DTCS.
• " " blinks when selecting CTCSS, or " " blinks when selecting
DTCS.
r Rotate [VOL] to select the desired subaudible tone.
t Push [✱•
] (or [D•
ENT CLR
and exit .
SET MODE
] to enter .
SET MODE
SET
D
]) to program the selected tone
SUBAUDIBLE TONES
When is selected from memory mode.
SET MODE
y Push [A•
], then push [C•
FUNC
contents to VFO.
• 3 beeps are emitted.
• VFO mode is selected automatically.
u Push [A•
], then push [C•
FUNC
• 3 beeps are emitted.
Steps y and u are necessary when overwriting the memory
contents permanently. The set tone frequency is used for
temporary operation only, therefore, these steps are not nec-
essary.
• Available CTCSS tone frequency list
67.0 85.4 107.2 136.5
69.3 88.5 110.9 141.3
71.9 91.5 114.8 146.2
74.4 94.8 118.8 151.4
77.0 97.4 123.0 156.7
79.7 100.0 127.3 159.8
103.5 131.8 162.2
82.5
9
] for 1 sec. to transfer the
MR
] for 1 sec.
MR
(unit: Hz)
165.5 186.2 210.7 254.1
167.9 189.9 218.1
171.3 192.8 225.7
173.8 196.6 229.1
177.3 199.5 233.6
179.9 203.5 241.8
183.5 206.5 250.3
9
33