Icom IC-V82 Instruction Manual page 80

13
CLONING
Cloning allows you to quickly and easily transfer the pro-
grammed contents from one transceiver to another trans-
ceiver.
D Transceiver-to-transceiver cloning
q Connect the OPC-474
the master and sub-transceivers.
• The master transceiver is used to send data to the sub-trans-
ceiver.
w While pushing [A•
turn power ON to enter cloning
mode (master transceiver only—
power ON only for sub-transceiver).
• "CLONE" appears and the transceivers
enter the clone standby condition.
68
POWER ON
AT
to the [SP] jack of
CLONING CABLE
] and [Y Y ],
FUNC
e Push [PTT] on the master transceiver.
• "CL OU" appears in the master transceiver's display and S-meter
indicator shows that data is being transferred to the sub-trans-
ceiver.
• "CL IN" appears automatically in the sub-transceiver's display
and S-meter indicator shows that data is being received from the
master transceiver.
r When cloning is finished, turn power OFF, then ON again
to exit cloning mode.
D Cloning using a PC
Please refer to the HELP file that comes with CS-V82
CLONING SOFTWARE
TRANSCEIVER
NOTE: DO NOT push the [PTT] on the sub-transceiver
PWR
during cloning. This will cause a cloning error.
A
FUNC
.
OPC-478 (RS-232C type)
to RS-232C port
OPC-478U (USB type)
to USB port
PC