Repeater Operation - Icom IC-V82 Instruction Manual

■ General
When using a repeater, the transmit frequency is shifted from
the receive frequency by the offset frequency. It is convenient
to program repeater information into memory channels.
q Set the receive frequency (repeater output frequency).
wPush [A•
] and [4•
FUNC DUP
"+."
• "–" indicates the transmit frequency is shifted down; "+" indicates
the transmit frequency is shifted up.
• Blinking "–" or "+" indicates the reversed duplex mode is selected
in (p. 58).
SET MODE
ePush [A•
] and [1•
FUNC TONE
subaudible tone encoder, if required.
• " " appears.
• Select the desired subaudible tone frequency, if necessary.
(p. 18)
r Push and hold [PTT] to transmit.
• The displayed frequency automatically changes to the transmit
frequency (repeater input frequency).
• If "OFF" appears, check the offset frequency (see right content
for details) and direction.
t Release [PTT] to receive.
yPush and hold [MONI] to check whether the other station's
transmit signal can be directly received or not.
About reversed duplex mode
When the reversed duplex mode is selected, the receive fre-
quency shifts. (Transmit frequency shifts in normal duplex
mode.)
] several times to select "–" or
] several times to activate the

REPEATER OPERATION

Each receive and transmit frequency is shown in the table
below with the following conditions;
IC-V82: Input freq.-145.30 MHz, Direction-negative, Offset frequency-0.6 MHz
IC-U82: Input freq.-439.80 MHz, Direction-negative, Offset frequency-5 MHz
IC-V82
Reversed OFF
Rx freq. 145.30 MHz 144.70 MHz 439.80 MHz 434.80 MHz
Tx freq. 144.70 MHz 145.30 MHz 434.80 MHz 439.80 MHz
■ Offset frequency
When communicating through a repeater, the transmit fre-
quency is shifted from the receive frequency by an amount
determined by the offset frequency.
q Push [A•
], then push [8•
FUNC
wPush [Y Y ] or [Z Z ] several times until "±" and offset frequency
appear.
eRotate [VOL] to select the desired offset frequency.
• Selectable steps are the same as the pre-set tuning steps.
• The unit of the displayed offset frequency is "MHz."
rPush [✱•
] (or [D•
ENT
exit .
SET MODE
IC-U82
ON OFF ON
SET MODE
USING
] to enter
SET SET MODE
]) to fix the offset frequency and
CLR
5
4
5
.
17