D Tx Message Programming - Icom IC-V82 Instruction Manual

11
DIGITAL MODE OPERATION
D D TX message programming
At least one of the TX message channels must be pro-
grammed, if you want to use the GPS message. The GPS
message is transmitted from TX message channels.
q While
OPTION SET MODE
then push [0• ] for 1 sec. to edit the message indication
OPT
then rotate [VOL] to select the message channel.
• One of either "C1" to "C6" blinks.
w Push [Y Y ] to set into message programming condition.
• The 1st digit blinks and channel indication stops blinking.
e Rotate [VOL] to set the desired character.
r Push [Y Y ] to select 2nd digit, then rotate [VOL] to set the
desired character.
• 2nd digit blinks (1st digit stop blinking).
• Repeat this step for programming.
t Push [0•
] to set the message.
OPT
y Repeat steps w to t to set another message channels.
u Push [✱•
] (or [D•
ENT
54
, push [Y Y ] (or [Z Z ]) to select "tXm,"
]) to exit
OPTION SET MODE
CLR
• Available characters
(space) (!) (")
(+) (,) (–)
(6) (7) (8)
(A) (B) (C)
(L) (M) (N)
(W) (X) (Y)
.
(#) ($) (%) (&) (') (( )
(.) (/) (0) (1) (2) (3)
(>)
(:) (;) (<) (=)
(9)
(E) (F) (G) (H) (I)
(D)
(O) (P) (Q) (R) (S) (T)
(Z) ([) (\)
(]) (^)
( )) (✱)
(4) (5)
(?)
(@)
(J) (K)
(U) (V)