CyberData 011395 Operation Manual page 58

Web Page Item
Nightringer Strobe Settings
Blink Strobe on Nightring
Scene
ADA Compliant
Slow Fade
Fast Fade
Slow Blink
Fast Blink
Color
Brightness
Red
Green
Blue
RTP Settings
RTP Port (even)
Jitter Buffer
Call Disconnection
Terminate Call After Delay
Codec Selection
Force Selected Codec
Codec
Operations Guide
Table 2-13. SIP Configuration Parameters (continued)
Description
The following strobe settings will only appear if you are using the Strobe Kit. If
you are not using the Strobe Kit, you will not see the strobe settings.
When selected, the Strobe will blink a scene when the Nightringer is ringing.
Select desired scene (only one may be chosen).
Strobe will blink ON at the specified brightness for 150ms then OFF for 350ms during
the duration of the event.
Strobe will increase in brightness from 0 to the specified brightness and back to 0 over
the course of about 3.5 seconds during the duration of the event.
Strobe will increase in brightness from 0 to the specified brightness and back to 0 over
the course of about 1.5 seconds during the duration of the event.
Strobe will blink ON at the specified brightness for one second then OFF for one
second during the duration of the event.
Strobe will blink ON at the specified brightness then OFF five times per second during
the duration of the event.
Select desired color (only one may be chosen).
How bright the strobe will blink when the Nightringer is ringing. This is the maximum
brightness for "fade" type scenes.
The red LED value for Nightringer.
The green LED value for Nightringer.
The blue LED value for Nightringer.
Use this button to preview the strobe flashing behavior for the Nightringer Strobe
Settings.
Specify the port number used for the RTP stream after establishing a SIP call. This
port number must be an even number and defaults to 10500. The supported range is
0-65536. Enter up to 5 digits.
Specify the size of the jitter buffer (in milliseconds) used for SIP calls. Valid values are
50-1000.
Automatically terminate an active call after a given delay in seconds. A value of 0 will
disable this function. Enter up to 8 digits.
When configured, this option will allow you to force the device to negotiate for the
selected codec. Otherwise, the device will perform codec negotiation using the default
list of supported codecs.
Select the desired codec (only one may be chosen).
931251F
Installing the Singlewire InformaCast Speaker
Configure the Speaker Parameters
CyberData Corporation
50