CyberData 011395 Operation Manual page 39

2. On the Device page, you may enter values for the parameters indicated in
Note
Web Page Item
Volume Settings (0-9)
Disable Volume Control Dial
SIP Volume
Multicast Volume
Ring Volume
Sensor Volume
Push To Talk Volume
Volume Boost:
No Volume Boost
+4dB
DTMF Settings
Require Security Code
Security Code
Enable DTMF Push to Talk
Monitor DTMF Toggle Key
Enable Stored Message Playback
Operations Guide
The question mark icon (
after the Toggle Help button is pressed
Table 2-7. Device Configuration Parameters
Description
Select this option to disable the volume control dial and enable digital
volume control settings.
Set the speaker volume for a SIP call. A value of 0 will mute the speaker
during SIP calls.
Set the speaker volume for multicast audio streams. A value of 0 will
mute the speaker during multicasts.
Set the ring volume for incoming calls. A value of 0 will mute the speaker
instead of playing the ring tone when Auto-Answer Incoming Calls is
disabled.
Set the speaker volume for playing sensor activated audio. A value of 0
will mute the speaker during sensor activated audio.
Set the speaker volume for Push to Talk operation. A value of 0 will mute
the speaker in Push to Talk mode.
Note: This setting will only appear if you are using the Talk-Back
Speaker.
Set the Boost level to increase the volume output of the speaker. Using
Volume Boost may introduce audio clipping and/or distortion. Boost is
only recommended for use with volumes set to level 9.
When selected, the user will be prompted to enter a Security Code
(entered on this page) before being able to execute a page when calling
the device.
Type the Security Code in this field. The Security Code must only use
characters '0-9', '*' and '#'. Enter up to 25 characters.
This option is for noisy environments.When enabled, in an active call the
remote phone can force receive only audio (setting the mic gain to max
and muting the speaker) by pressing the '*' key. Pressing the '#' key will
force send only audio (setting the max speaker volume and muting the
mic). Pressing the '0' key will restore full duplex operation with the
normal microphone and speaker volume.
Note: This setting will only appear if you are using the Talk-Back
Speaker.
Specify the key that toggles between monitor mode's 'talk' and 'listen'
state. Defaults to '#'.
Note: Some PBX's use # for other call functions
When selected, the caller will be prompted to select one of nine stored
messages to play through the speaker. Stored messages may be
customized on the Audiofiles page.
931251F
Installing the Singlewire InformaCast Speaker
) in the following table shows which web page items will be defined
.
Configure the Speaker Parameters
Table 2-7.
CyberData Corporation
31