Memory Output - Ahlborn ALMEMO 6290-7B Operating Instructions Manual

8.6.2 Memory Output

When all parameters of the memory output have been set according to section
8.6.1 the output can be started by using the key START/STOP. The printouts
correspond, depending on the output mode of the list of measured values (see
8.3.2), to the line plots (see 8.4) or to the interface logs (see man. 6.6.1). The
memory can be recalled as often as desired and in any format and scaling.
During the memory output ´S Out ´ is indicated in the display and the following
key functions are available:
START/STOP
MEASURE
FUNCTION
CH▲ / Clr
Special Functions
During interface operation the measuring instrument with built-in printer also
supports the identification of measurements with a number, as well as the
selective memory output corresponding to these numbers (see man. 6.8 and
6.9.2.3). For example, a barcode reader can be used locally for the input of a
number (see manual 5.2.4).
With a corresponding configuration the measuring instrument with built-in
printer can also record individual measuring points at a rate of 10
measurements/second (see man. 6.5.1.3) and can plot the measurement at a
later point in time.
Stop of the automatic memory output
Output of individual measured values
Start of the automatic memory output
Termination of the automatic memory output

ALMEMO
Data Memory
6290-7B 44