Ahlborn ALMEMO 6290-7B Operating Instructions Manual page 44

Data Memory
For separating between memory functions and normal functions the arrow ´F´
is indicated in the display.
In function MEMORY FREE ´MF´ the free
memory space is indicated in kilobytes.
By selecting the OUTPUT MODE ´OM´ (see 8.1) every data log can be
subsequently output in any output format. Furthermore, the memory function
´OM´ provides the option ´dr AL´ that allows to only print out the alarm values
from one entire measurement.
Display Printout Function
dr PRINT
Pl 1 PLOT 1
Pl 2 PLOT 2
U U
dr AL PRINT
The parameters PLOT RANGE BEGIN ´PS´ and PLOT RANGE END ´PE´ are
first received from the sensor programming for each channel (see 8.4.1).
However, they can be altered, as required, for the output. This allows for a new
channel selection and, along with the time interval, also for zooming in any
direction.
The functions START TIME ´ST´ and END TIME ´ET´ and START DATE ´SD´
and END DATE ´ED´ allow for a selection and output of an extract from any
part of the memory area. The data input corresponds to the input of the time
and date (see 7.2.4).
Start time ´ST´
End time ´ET´
Programming in format hh:mm:ss according to 5.4.
Start date ´SD´
End date ´ED´
Programming in format dd:mm:yy according to 5.4.
The values can be cleared by using the keys ENTER, Clr.
If another function is selected in function MEMORY ´MY´ by using the key
MEASURE, the normal functions are available again when using the key
FUNCTION (see 5.2).
43
list output to the built-in printer
line plot in 1 diagram to the built-in printer
line plot in 2 diagrams to the built-in printer
list output to serial interface
list output alarm values only to the built-in printer
Selection with key FUNCTION..
Selection with key FUNCTION..
Selection with key FUNCTION..
Selection with key FUNCTION..

ALMEMO 6290-7B
2 3 4.5
0 7:3 0:0 0
1 8:0 0:0 0
3 1.0 5.9 9
3 1.0 5.9 9
MF
S T
E T
S D
E D