Measured Values And Max And Min Values; Plot - Ahlborn ALMEMO 6290-7B Operating Instructions Manual

If the function RANGE ´R´ is selected during start, a header with the
programming will be printed at the beginning. It is also possible to provide an
individual designation in the header (see manual 6.2.4).
Printout for cyclic measuring point scan with output of the header:
ALMEMO 6290-7
CH RANGE LV MAX LV MIN D COMMENT
1: NiCr + 80.0 + 75.0 °C Temperature
3: °orH - - -
PRINT CYCLE: 00:00:10
DATE: 01.01.99
12:50:05 1: + 78.3 °C 3: + 51.8 %H
12:50:15 1: + 79.2 °C 3: + 51.1 %H
12:50:25 1:!+ 80.5 °C 3: + 50.4 %H
12:50:35 1:!+ 73.8 °C 3: + 49.7 %H
12:51:45 1: - - - °C 3: + 48.1 %H
To stop the automatic printout the key START/STOP must be pressed.

8.3.3 Measured Values and Max and Min Values

If the key START/STOP is operated in function Max Value ´MH´ or Min Value ´ML´
a list of the current measured, maximum and minimum values of all connected
sensors are printed.
Printout:
CH MEAS.VAL MAX.VAL MIN.VAL DIM
01:+0023.0 +0025.0 +0019.0 °C
03:+0028.1 +0034.5 +0029.9 %H

8.4 Plot

As an alternative for the list of measured values the measured values can also
be printed as a line plot. By using the output mode PLOT 1 ´PL 1´ up to four
measuring points will be printed in a diagram using the entire printing width. In
output mode PLOT 2 ´Pl 2´ two measuring points will be printed in two
separate diagrams, side by side, with half of the printing width. In both cases,
only the active channels providing a programming for plot start and plot end will
be considered so that unwanted channels can be masked.
For monitoring the exceeding of limit values or for a better orientation, a dotted
reference line is printed in addition to each measuring point. For identification
of the channels the lines will be provided with the number of the measuring
point after each printout of the time.
5.50
- - - %H Humidity
PRINT
ALMEMO
1899
header
programming
print cycle, output mode
measured values
overshooting of limit value
undershooting of limit value
sensor breakage

6290-7B
Digital Data Output
36