Table of Contents
Advertisement
Display and Keyboard
from those used for the recording of measuring data (see 8.6.1) if a data
memory has been integrated (option S).
The instruments can be individually configured for any application by setting
the functions of the key FUNCTION via interface (AMR-Control) (see man.
6.10.13.3). For this purpose, this key corresponds to the key F. Even the
storage of a configuration in an ALMEMO
i.e. the functions can then also be activated by programming modules that
were formerly required.
The additional activated functions are cleared by operating the key CLEAR
during the switch-on.
5.3 Keyboard
The keyboard (6) has the following functions that are displayed above the keys:
Function
Programming of Parameters
Selecting Measuring Points
Selecting Measuring Functions
Selecting Programming Functions
Start and Stop of Measurements
Line Feed
When the key ENTER is operated a digit or an abbreviation is flashing in the
display, i.e. the instrument is in edit mode and the white designations on the
keys are valid. The keys
figure, $, operate as cursor keys and the key Clr is available for clearing
parameter data. The input is complete, when the last digit has been confirmed
with operating the key $.
19
, " and # are then available for altering the input
!
ALMEMO
6290-7B
configuration connector is possible,
Normal
ENTER
CH ▲
MEASURE
FUNCTION
START/STOP
PAPER FEED
Enter
$
Clr
"
#
!
Advertisement
Table of Contents
