Set The Analog Output Port Assignment - Ahlborn ALMEMO 500 Supplementary Instructions Manual

5 How to use the RTA6 Slide-in Module
By using the function
respectively stopped as soon as a signal has been transmitted via
the trigger input to the data logger.
By using the function
be started as long as a signal is transmitted via the trigger input to
the data logger. The measurement will be stopped as soon as the
signal is no longer transmitted via the trigger input to the data logger.
Start execution of a macro with trigger signal
1. Tick the checkbox next to
2. Tap on the field next to
3. Tap on the macro you want to execute with the trigger signal.
4. Tap on the arrow
5. Tap on the field next to the macro you want to set.
6. Enter the ALMEMO
that shall be carried out when the macro is executed (see Instruction Manual
2020 chapter 6.6.5 Macros).
7. Tap next to the field.
➢ The macro will be executed as soon as a trigger signal is received by the
data logger via the port.

5.5.4 Set the Analog Output Port Assignment

Transmit measured values of one specific measuring channel to the analog
output
1. In the home screen of the app tap on the button
2. Tap on the arrow
3. Tap on the arrow
®
ALMEMO
whose measured values are transmitted to the analog output.
4. Tap on the arrow
5. Tap on the arrow
want to establish the analog output.
- 16 –
Start-Stop
Start-St. level triggered
Macro execution
Variant.
>
in the line
®
commands (in the format intended for that purpose)
>
in the line
>
in the line of the measuring circuit board to which the
sensor is connected, to which the measuring channel belongs
>
in the line
>
in the line of the RTA6 slide-in module, in which you
the measurement will be started
.
Macros.
Device list.
Output module.
the measurement will
.