Print Cycle; Time And Date - Ahlborn ALMEMO 6290-7B Operating Instructions Manual

7.2.3 Print Cycle

At all measurements the print cycle causes a cyclic measuring point scan of all
active measuring points and an output of the measured values to a display,
printer, memory (option) or interface. The time can be set between 1s and 12h.
The print cycle cannot be accessed in PLOT mode. It is set by entering the
paper feed in function ´PF´ (see 8.4.2), i.e. only if the output mode is set to ´dr´,
´U´ or ´S´ the function print cycle ´PC´ can be selected by using the key
FUNCTION.
Function PRINT CYCLE ´PC´
Selection with key:
The print cycle is programmed using the 6-digit format hh:mm:ss (see 5.4).
The key CH▲ can be used to switch the continuous conversion rate (see
manual 6.5.1.3) on or off. For control purposes a dot is displayed following the
print cycle.
Clear print cycle:
A running cyclic scan is terminated by this.

7.2.4 Time and Date

For recording the measuring time a real time clock with date function has been
integrated into the ALMEMO
allowing for time and date to be maintained when the unit is being switched off.
Function TIME ´TM´
Selection with key FUNCTION...
The input format for time and date is hh:mm:ss (see 5.4).
The clock can be stopped/set to zero by using the keys ENTER, Clr.
The clock can be started in any switch position by operating key START/STOP.
Function DATE ´DA´
Selection with key FUNCTION...
The input format for the date is dd.mm.yy (see 5.4). The year number can also
be provided as output with 4 digits (see manual 6.10.13) via interface.
The date can be cleared by using the keys ENTER, Clr.
FUNCTION
...
Example: print cycle 30 min.
ENTER
Clr
,

6290-7B. It is equipped with a lithium battery
Example: date 1st May, 1999

ALMEMO
Measuring Point Scan
0 0:3 0:0 0
0 0:0 0:0 0
1 2:3 4:5 6
0 1:0 5:9 9
6290-7B
.PC
PC
TM
DA
32