GE L30 Instruction Manual page 286

5.6 GROUPED ELEMENTS
SETTING
NEG SEQ OV1
FUNCTION:
Disabled = 0
Enabled = 1
SETTING
NEG SEQ OV1 BLOCK:
Off = 0
SETTING
NEG SEQ OV1 SIGNAL
SOURCE:
Wye VT
Delta VT
V_2
e) AUXILIARY UNDERVOLTAGE (ANSI 27X)
PATH: SETTINGS GROUPED ELEMENTS
AUXILIARY UV1
5
The L30 contains one auxiliary undervoltage element for each VT bank. This element is intended for monitoring undervolt-
age conditions of the auxiliary voltage. The
ment starts timing. The nominal secondary voltage of the auxiliary voltage channel entered under
SETUP AC INPUTS
pickup level.
The setting selects the minimum operating time of the auxiliary undervoltage element. Both
AUX UV1 DELAY
and settings establish the operating curve of the undervoltage element. The auxiliary undervoltage element
AUX UV1 DELAY
can be programmed to use either definite time delay or inverse time delay characteristics. The operating characteristics
and equations for both definite and inverse time delay are as for the phase undervoltage element.
5-150
SETTING
NEG SEQ OV1 PICKUP:
AND RUN
V_2 or 3 × V_2 PKP
3 × V_2
Figure 5–71: NEGATIVE-SEQUENCE OVERVOLTAGE SCHEME LOGIC
SETTING GROUP 1(6)
AUX UV1
FUNCTION: Disabled
AUX UV1 SIGNAL
MESSAGE
SOURCE: SRC 1
AUX UV1 PICKUP:
MESSAGE
0.700 pu
AUX UV1 CURVE:
MESSAGE
Definite Time
AUX UV1 DELAY:
MESSAGE
1.00 s
AUX UV1 MINIMUM:
MESSAGE
VOLTAGE: 0.100 pu
AUX UV1 BLOCK:
MESSAGE
Off
AUX UV1 TARGET:
MESSAGE
Self-reset
AUX UV1 EVENTS:
MESSAGE
Disabled
AUX UV1 PICKUP
VOLTAGE BANK X5 AUXILIARY VT X5 SECONDARY
L30 Line Current Differential System
SETTINGS
NEG SEQ OV1 PICKUP
DELAY:
NEG SEQ OV1 RESET
DELAY:
t
PKP
t
RST
≥
VOLTAGE ELEMENTS
Range: Disabled, Enabled
Range: SRC 1, SRC 2
Range: 0.000 to 3.000 pu in steps of 0.001
Range: Definite Time, Inverse Time
Range: 0.00 to 600.00 s in steps of 0.01
Range: 0.000 to 3.000 pu in steps of 0.001
Range: FlexLogic™ operand
Range: Self-reset, Latched, Disabled
Range: Disabled, Enabled
selects the voltage level at which the time undervoltage ele-
is the per-unit base used when setting the
5 SETTINGS
FLEXLOGIC OPERANDS
NEG SEQ OV1 PKP
NEG SEQ OV1 DPO
NEG SEQ OV1 OP
827839A3.CDR
AUXILIARY UV1
SETTINGS SYSTEM
AUX UV1 PICKUP
GE Multilin