4 HUMAN INTERFACES
•
GROUP 1...6: The illuminated GROUP is the active settings group.
•
BREAKER 1(2) OPEN: The breaker is open.
•
BREAKER 1(2) CLOSED: The breaker is closed.
•
BREAKER 1(2) TROUBLE: A problem related to the breaker has been detected.
•
SYNCHROCHECK NO1(2) IN-SYNCH: Voltages have satisfied the synchrocheck element.
•
RECLOSE ENABLED: The recloser is operational.
•
RECLOSE DISABLED: The recloser is not operational.
•
RECLOSE IN PROGRESS: A reclose operation is in progress.
•
RECLOSE LOCKED OUT: The recloser is not operational and requires a reset.
The relay is shipped with the default label for the LED panel 2. The LEDs, however, are not pre-programmed. To match the
pre-printed label, the LED settings must be entered as shown in the User-programmable LEDs section of chapter 5. The
LEDs are fully user-programmable. The default labels can be replaced by user-printed labels for both panels as explained
in the following section.
a) ENHANCED FACEPLATE
The following procedure requires the pre-requisites listed below.
•
EnerVista UR Setup software is installed and operational.
•
The L30 settings have been saved to a settings file.
•
The L30 front panel label cutout sheet (GE Multilin part number 1006-0047) has been downloaded from
www.GEindustrial.com/multilin/support/ur
•
Small-bladed knife.
This procedure describes how to create custom LED labels for the enhanced front panel display.
1.
Start the EnerVista UR Setup software.
GE Multilin
Figure 4–21: LED PANEL 2 (DEFAULT LABELS)
and printed.
L30 Line Current Differential System
4.3 FACEPLATE INTERFACE
842784A1.CDR
4.3.3 CUSTOM LABELING OF LEDS
4
http://
4-17