FP postbase Operator's Manual And Parts List page 25

Slide rail
(magnetic)
On the Dynamic Scale
Guide plate
• Lift the Feeder plus slightly, align to the
• Fit the remaining components in the same
On the Ramp plus
Attaching the letter guide
• Place the letter guide in the magnetic guide
Letter guide
Mounting the guide plate
• Fold the hood up.
• Release the fastening screw with the Torx
• Insert the guide plate – as shown in the
• Tighten the fastening screw.
Fastening screw
• Close the hood.
(pre-fitted)
You can remove the protective films applied
to protect sensitive surfaces (display, weigh-
ing platform, sealant tank flap).
Installation and commissioning
Ramp plus (see illustration on page 24)
and carefully set down on the Ramp plus.
The catches must latch into the slots on the
bottom side of the Feeder plus here.
way.
rail from the front and slide it into place.
tool supplied (roughly 1 revolution).
illustration – in the slot of the Dynamic
Scale and slide in to the stop.
25