Panasonic fp2/fp2sh User Manual page 355

Error
Name
code
Configu-
ration
E29
parameter
error
Interrupt
E30
error 0
Interrupt
E31
error 1
Interrupt
E32
error 2
Multi-CPU
data
E33
unmatch
error
I/O status
E34
error
MEWNET-F
slave
E35
illegal unit
error
MEWNET-F
(remote
E36 I/O)
limitation
error
MEWNET-F
I/O
E37
mapping
error
Opera-
tion Description and steps to take
status
A parameter error was detected in the
Stops MEWNET-W2 configuration area. Set a
correct parameter.
Probably a hardware abnormality.
Stops
⇒ Please contact your dealer.
An interrupt occurred without an interrupt
request . A hardware problem or error due to
Stops noise is possible.
⇒ Turn off the power and check the noise
conditions.
There is no interrupt program for an interrupt
which occurred.
⇒ Check the number of the interrupt program
Stops
and change it to agree with the interrupt
request..
This error occurs when a FP3/FP10SH is
CPU2
used as CPU2 for a multi-CPU system.
Stops
⇒Refer to "Multi-CPU system Manual".
An abnormal unit is installed.
-FPΣ, FP0R(FP0R mode),FP-X, FP2,FP2SH
and FP10SH:
Check the contents of special data register
DT90036 and locate the abnormal unit. Then
turn off the power and replace the unit with a
Stops
new one.
-FP3:
Check the contents of special data register
DT9036 and locate the abnormal unit. Then
turn off the power and replace the unit with a
new one.
A unit, which cannot be installed on the slave
station of the MEWNET-F link system, is
Stops installed on the slave station.
⇒Remove the illegal unit from the slave
station.
The number of slots or I/O points used for
MEWNET-F(remote I/O) system exceeds the
limitation.
Stops
⇒Re-configure the system so that the
number of slots and I/O points is within the
specified range.
I/O overlap or I/O setting that is over the
range is detected in the allocated I/O and
Stops
MEWNET-F I/O map.
⇒Re-configure the I/O map correctly
A
A A A A A A
A A A A A A
A A A
A
A
A
A: Available
A
A A
A A
A A
A A
A A
A A
A A
11-87