Panasonic fp2/fp2sh User Manual page 299

FP2/FP2SH/FP10SH/FP3 (A: Available, N/A: Not available)
Address
FP2/
FP3 FP2SH
FP10SH
DT9018 DT90018
DT9019 DT90019
DT9020 -
- DT90020
DT9021
-
(*Note)
DT90021
-
(*Note)
Note) Used by the system.
Name
The address where an operation error
occurred is stored. Each time an error
occurs, the new address overwrites the
previous address. At the beginning of
Operation error scan, the addresses 0. Monitor the
address address using decimal display.
(non-hold) FP2SH:
When the higher byte of DT90257 is H2,
the error occurs in the 2nd program
block. In case of the 1st program block, it
is H1.
The data stored here is increased by one
every 2.5 ms (H0 to HFFFF)
2.5 ms ring
Difference between the values of the two
counter
points (absolute value) x 2.5 ms =
Elapsed time between the two points.
Maximum value
of program The last address of sequence program
(Available PLC: area set in system register 0 is stored.
FP3)
The program capacity is stored in
Display of
decimal.
program
Example:
capacity
K30: approx. 30 K steps
(Available PLC:
K60: approx. 60 K steps (with memory
FP10SH)
expansion)
The program capacity is stored in
Display of
decimal.
program
Example:
capacity
K16: approx. 16 K steps (K15870)
(Available PLC:
K32: approx. 32 K steps (with memory
FP2)
expansion)
Maximum value
of file register The maximum (last) address of the file
(Available PLC: registers available are stored in here.
FP3)
Maximum value
of file register The maximum (last) address of the file
(Available PLC: registers available are stored in here.
FP2/FP10SH)
Descriptions
Read- Writ-
ing ing
A N/A
N/A N/A
11-31