Panasonic fp2/fp2sh User Manual page 283

FP2/FP2SH/FP10SH
Add-
Item
ress
Tool port Baud rate setting for the
414
setting tool port
Communication method
412
setting for COM port
Communication format
setting (Common setting
for both computer link
and serial data
communication)
When used for computer
413
link, the start and end
code settings of format
for MEWTOCOL-COM will
COM
not be effective.
port
Available PLC: FP2/
setting
FP2SH
Baud rate setting for the
COM port
414
Available PLC: FP2/
FP2SH
Unit number setting for
COM port
415
Available PLC: FP2/
FP2SH
Modem compatibility
setting for COM port
416
Available PLC: FP2/
FP2SH
Starting address setting
for received buffer of
417 serial data
General
communication mode
commu-
(data register number)
nication
Capacity setting for
setting
received buffer of serial
418
data communication
mode (word number)
Default
Name
value
19200 bps
FP2: Not
used
FP2SH/
FP10SH:
Computer
link
Character
bit: 8 bits,
Parity chk:
"With,
odd"
Stop bit:
1 bit,
End code:
CR,
Start
code:
NO STX
19200 bps
1
Modem
disabled
0
1024
Descriptions
In the FP10SH, when the dip switch
SW1 on the CPU is off, the baud rate
setting is effective.
In the FP2/FP2SH, when the dip
switch SW1 on the rear of the CPU is
off, the baud rate setting is effective.
19200 bps 19200 bps
1200 bps 38400 bps
2400 bps 57600 bps
4800 bps 115200 bps
9600 bps
UNUSED: COM port is not used.
COMPUTER LINK: computer link
mode (when connecting C-NET)
GENERAL: serial data communication
mode
Character bit: 7 bits/8 bits
Parity chk: non/with odd/with even
Stop bit: 1 bit/2 bits
End code: CR/CR+LF/NON/ETX
Start code: NO STX/STX
19200 bps 19200 bps
1200 bps 38400 bps
2400 bps 57600 bps
4800 bps 115200 bps
9600 bps
1 to 99 (unit No. 1 to 99)
Modem enabled/Modem disabled
When connecting a modem, set the
unit number to 1 with system register
415.
FP2SH/FP10SH:
0 to 10240 For details about
FP2: 0 to 5999 its usage, refer to
the F144 (TRNS)/
P144 (PTRNS)
instructions.
0 to 1024
11-15