Panasonic fp2/fp2sh User Manual page 266

Specifications
10.3 Relays, Memory Areas and Constants
Item Item
Control Master control relay points
instruction (MCR)
point i t
Number of labels (JP and
LOOP)
Number of step ladder
(* Note 4)
Number of subroutine
Number of interrupt program
Constant Decimal constants
Hexadecimal
constants constants
Decimal constants
(monorefined real
number)
Notes
1) There are two unit types, the hold type that saves the condi-
tions that exist just before turning the power off or changing
from the RUN mode to PROG. mode, and the non-hold type
that resets them. The selection of hold type and non-hold type
can be changed by the setting of system register.
2) The points for the timer and counter can be changed by the
setting of system register 5. The numbers given in the table
are numbers when system register 5 is at its default setting.
3) The size of the file register varies depending on the settings of
system registers 0, 1 and 2.
4) Hold or non-hold type can be set using the system registers.
10 − 12
Numbering
FP2/FP2SH
256 points
Total: 256 points
1,000 steps
100 subroutines
1 program (periodical interrupt: allows setting of the time interval
within the range from 0.5ms to 1.5s)
(K) K−32768 to K32767 (for 16-bit operation) ( )
K−2147483648 to K2147483647 (for 32-bit operation)
(H) H0 to HFFFF (for 16-bit operation) ( )
H0 to HFFFFFFFF (for 32-bit operation)
−38
(f) f−1.175494×10
to f−3.402823×10
−38
f1.175494×10 to f3.402823×10
FP2/FP2SH
38
38