Panasonic fp2/fp2sh User Manual page 288

FP2/FP2SH/FP10SH
Address
R9020 RUN mode flag
R9021
Test RUN mode flag
(*Note)
R9022
Break flag
(*Note)
R9023
Break enable flag
(*Note)
Output update enable
R9024
flag in the test RUN
(*Note)
mode
R9025
Single instruction flag
(*Note)
R9026
Message flag
(*Note)
R9027
Remote mode flag
(*Note)
R9028
Break clear flag
(*Note)
R9029
Forcing flag
)
(*Note)
External interrupt
enable flag
R902A (Available PLC:
(*Note) FP2SH/FP10SH)
Interrupt flag
(Available PLC: FP2)
R902B
Interrupt error flag
(*Note)
R902C
Sampling point flag
(*Note)
R902D Sampling trace end
(*Note) flag
R902E
Sampling trigger flag
(*Note)
R902F
Sampling enable flag
(*Note)
Note) Used by the system.
11-20
Name
Turns off while the mode selector is set to PROG.
Turns on while the mode selector is set to RUN.
Turns on while the initialize/test switch of the CPU is set to
TEST and mode selector is set to RUN. (test run operation
start)
Turns off during the normal RUN mode.
Turns on while the BRK instruction is executing or the step
run is executing.
Turns on while the BRK instruction is enabled in the test
RUN mode.
Turns on while the output update is enabled in the test RUN
mode.
Turns on while the single instruction execution is selected in
the test RUN mode.
Turns on while the F149 (MSG)/P149 (PMSG) instruction is
executed.
Turns on while the mode selector is set to REMOTE.
Turns on when the break operation is cleared.
Turns on during forced on/off operation for I/O relay and
timer/counter contacts.
Turns on while the external interrupt trigger is enabled by
the ICTL instruction.
Turns on while the periodical interrupt is executed by the
ICTL instruction.
Turns on when an interrupt error occurs.
Turns off during instructed sampling.
Turns on while sampling is triggered by the periodical
interrupt.
Turns on when the sampling trace ends.
Turns on when the sampling trace trigger of the F156
(STRG)/P156 (PSTGR) instruction is turned on.
Turns on when the starting point of sampling is specified.
Description