NOTE: IF THE CODE APPEARS MORE THAN THREE TIMES, THE LCD SCREEN WILL LOCK ITSELF UP.
THIS PELLET FURNACE IS EQUIPPED WITH MULTIPLE DEVICES TO ENSURE YOUR SAFETY. IF A
WARNING ERROR CODE STOPS YOUR FURNACE ON SEVERAL OCCASIONS, IT IS MORE THAN
LIKELY THAT THE FURNACE DOES NOT EXHAUST PROPERLY.
do a COMPLETE furnace maintenance as described in this manual.
For an Over-heat Code
•
Service the furnace COMPLETELY as described in this manual. See Section 9:
Maintenance.
•
Verify the venting system and all other components mentioned above.
ONCE THE MAINTENANCE DONE AND THE VENTING SYSTEM CHECKED, FOLLOW THESE
INSTRUCTIONS
After 3 attempts press reset
999333555
10.3.7 HOPPER LID OPEN
❖ The hopper lid remained open for more than 3 minutes. As a security measure, the rotary valve
stops turning and feeding pellets as soon as the hopper lid opens. It will resume normal operations as
soon as the hopper lid is closed. If the hopper lid stays open for more than 3 minutes, the furnace will
stop.
Before resetting the PC board displaying an error code,
and press accept. The system will reset.
and then enter the following code
70