Table of Contents
Advertisement
Before putting the blower box
cover back on, the furnace
must be plugged to an 115V
current source. To do that,
remove
one
of
the
three
knockouts that allow the easiest
connection depending on your
installation.
Join the power cord to the
Neutral (N), Ground (F) and
Line (L) terminals. Refer to the
wiring diagram (Section 14) for
the
other
components
connections.
Once
done,
secure the wires with a BX
connector (not included) and
put the blower box cover back.
5.11 INSTALLING THE LCD USER INTERFACE
The LCD touch interface is used to operate the
system. It must be installed on the support
intended for this purpose in front of the furnace
on the same side as the link board housing.
33
Hide quick links:
Advertisement
Table of Contents
