Table of Contents
Advertisement
ASH DRAWER
Your furnace is equipped with an ash drawer to collect ashes produced by the combustion of pellets. This drawer
must not be left open during combustion as this may cause ash dispersion through the ductwork.
The drawer must be emptied regularly. Once clean-up is completed, use an ash vac to carefully remove any
ash around the drawer. Failure to perform this important step may cause ashes to be dispersed through the
ductwork.
It is important that the door and the ash drawer be kept closed while the appliance is in use.
Maintain all gaskets in good condition; in case of deterioration, contact your dealer for a
genuine replacement gasket.
3. APPLIANCE INSTALLATION
REMOVING THE HOPPER AND BLOWER ASSEMBLY (IF REQUIRED)
Should you need to install the furnace in an area that if difficult to access, both the hopper and blower assembly
located at the back of the furnace may be removed. To do so, follow the instructions below.
Hopper removal
1-
Remove the screws
from the protection cover
(keep the screws). Remove
the cover.
7
Advertisement
Table of Contents
