HOPPER'S LID OPENING
5.3
The standard hopper's opening is from the back to the front. However, it is possible to change the opening
direction of the hopper's lid to facilitate the pellet filling of the hopper depending on the different ducts installation
(chimney, fresh air return, fresh air inlet, etc.). For that, open the hopper's lid, unscrew the three screws holding
each of the hinges, rotate the lid 180° and put the hinges in place with the holes intended for this purpose at the
back of the hopper using the same six screws removed previously.
Note: When finished, make sure the lid, when closed, rest well on the safety switch.
16