Table of Contents
Advertisement
2.9
INSTALLING THE LCD USER INTERFACE
The LCD user interface (touchscreen) is used for the system's operation. In order to secure it, you need to install the
LCD user interface support using two screws (two holes are designed for this installation on the furnace). The LCD
user interface support and the two screws are supplied with the owner's manual.
The LCD user interface must be secured to the support. Then, connect the main control board to the LCD user
interface. In order to do so, use the white cable already connected to the main control board and pushes this cable
through the hole above the access panel to the main control board. Simply run the cable along the side of the
furnace using the plastic clips supplied with the owner's manual as shown below. Secure the access panel to the
main control board back in place. Please note that the LCD user interface is removable if access is limited.
LCD user
interface support
26
PLASTIC
CLIPS
WHITE WIRE
TELCO WIRE
Advertisement
Table of Contents
