Quick Connector; Ring Terminal Cable - ProCharger 600 Manual

recommend permanent connection (without mains power connection) for vehicles
which are regularly moved and charged.
Charging duration
Please note that the charging processes may take different lengths of time. The
charging process for a battery with a capacity of more than 20 Ah, for example, can
easily take two days, depending on the condition of the battery (old or new; flat or
deeply discharged etc.).

10. Quick connector

You can use the ProCharger quick connector to connect charger clamp cables, ring
terminal cables and other compatible ProCharger accessories to the ProCharger
charger. To do so, both parts of the quick connector are joined together so that they
engage in place. The plug-in connector on the quick connector is reverse polarity
protected and can only be connected in one position.
To disconnect this connection, you have to actuate the red rocker on the plug-in
connector. and unfasten the connector by gently pulling it apart. In the process, never
pull or push on the cable; always take hold of the housing of the plug-in connector.

11. Ring terminal cable

The ring terminal cable is designed for permanent connection to the vehicle battery.
First disconnect the motorcycle earth connection from the battery. Then, screw the red
ring connector (plus) of the ring terminal cable on the battery's positive terminal. Then,
screw the black ring connector (minus) of the ring terminal cable on the battery's
negative terminal. Then, re-connect the motorcycle's earth connection to the negative
terminal on the battery. In the process, proceed with care. It is imperative that you
prevent short circuits and make sure the contact is secure. The ring terminal cable
31