ProCharger 600 Manual page 29

• If the battery contacts are difficult to access or the terminals of the charger could
come into contact with adjacent components, the battery will also need to be
removed. Adhere to the manufacturer specifications on removal of the battery.
• Make sure that the charger is initially not connected to the mains socket.
• It is imperative to adhere to the following connection sequence:
• Option A - Charging the battery with the charging clamp cable while installed:
Connect the charging clamp cable to the charger using the quick connector
(if you have not already done so). Then, first connect the red charging
clamp (plus) to the positive terminal on the battery. After doing so, connect
the black clamp (minus) to the vehicle chassis or the engine block, but
not in the vicinity of the battery, the fuel supply line or the carburettor, and
not to metal clips or moving parts. The negative terminal of the charger is
connected to the vehicle chassis or to the engine block in accordance with
the EN standard, i.e. a little distance away from the battery. This prevents
explosive gases which may be in the direct vicinity of the battery, from
igniting due to sparks on the battery terminal.
• Option B - Charging the battery with the charging clamp cable while
removed:
Connect the charging clamp cable to the charger using the quick connector
(if you have not already done so). Then, first connect the red charging
clamp (plus) to the positive terminal on the battery. Then, connect the black
clamp (minus) to the negative terminal on the battery.
• Option C - Charging with the ring terminal cable:
First disconnect the motorcycle earth connection from the battery. Then,
screw the red ring connector (plus) of the ring terminal cable on the
battery's positive terminal. Then, screw the black ring connector (minus) of
the ring terminal cable on the battery's negative terminal. Then, re-connect
the motorcycle's earth connection to the negative terminal on the battery.
Then, connect the ring terminal cable to the charger using the quick
connector.
• Then, connect the battery charger to the mains power. The "
• The charging process then starts automatically and is signalled by the "
• The battery is fully charged when the "
(for further information – see the section "End of charging").
• After the charging process, first disconnect the charger from the mains power.
• It is imperative to adhere to the following disconnection sequence:
• Option A - Charging the battery with the charging clamp cable while installed:
First disconnect the black charging clamp (minus) from the vehicle chassis
" LED goes out or lights up only dimly
" LED lights up.
" LED.
29