Fuse; Specifications - ProCharger 600 Manual

has to be attached to the vehicle so that it cannot be trapped, does not rest directly
on the hot motor and is kept away from all moving parts. Since this is a universal
product, you must make sure that the ring terminal cable can be used properly and
without problems with your type of vehicle before using it for the first time. In the
process, it is imperative that you adhere to the specifications and guidelines of the
vehicle and battery manufacturer.

12. Fuse

If the charging process does not start, the 10 A flat fuse in the charging cable may be
faulty. In this case, replace the fuse and check the cabling.

13. Specifications

Operating voltage.................................................. 220 - 240 V/AC (50/60 Hz)
End-of-charge voltage........................................... 13.8 V
Charging current .................................................. max. 600 mA
Housing protection class....................................... IP 40
Operating conditions............................................. -15°C to +45°C, 10% to 90%
Storage conditions................................................ -30°C to +60°C, 10% to 90%
Dimensions (W x H x D)........................................ 51 x 94 x 35 mm
Weight................................................................... approx. 190 g
Length of charging cable (total)............................ approx. 230 cm
Fuse protection for charging cable....................... 10 A
32
relative air humidity,
non-condensing
relative air humidity,
non-condensing