Product Description; Quick-Start Guide - ProCharger 600 Manual

1. Product description

The ProCharger 600 is an automatic plug-in charger for all 12 V (6 cells) lead-acid,
lead-gel, lead-fleece (AGM) or calcium vehicle batteries. The I-U charging principle
charges the battery with a maximum charging current of 600 mA at the beginning
until the end-of-charge voltage for the connected battery is reached. The charger
then switches to constant voltage and reduces the charging current (trickle charging
function). The battery voltage is constantly kept at the ideal charge level. The plug-in
charger is safeguarded against short circuit and reverse polarity.
The ProCharger 600 is not suitable for charging Li-ion vehicle batteries.
Before you put the device into operation, read these operating instructions thoroughly.
This is the only way to familiarise yourself with all the functional options, prevent
incorrect operation and protect yourself and your device from possible damage as a
result of improper use.

2. Quick-start guide

Beforehand, read the Safety instructions and the points Preparation, connection
and operation.
1. Connect one of the charging cables (with charging clamps or ring connectors)
to the charger using a quick connector.
2. Connect the charging clamps or ring connectors to the battery with the correct
polarity (the black clamp (minus) to the vehicle chassis or the engine block when
the battery is installed).
3. Connect the plug-in charger to the socket. The "
4. The charging process then starts automatically and the "
The charging process is complete when the "
information – see the section "End of charging" in chapter 9).
5. Disconnect the plug-in charger from the socket.
6. Disconnect the charging clamps from the battery (or the black charging clamp
from the vehicle chassis or engine block if the battery is installed) or disconnect
the charging cable with the ring connectors from the charger using a quick
connector.
22
" LED lights up.
" LED lights up.
" LED goes out (for further