Installing the Out-Front Mount
1 Select a secure location to mount the Edge device where it does not inter-
fere with the safe operation of your bike.
2 Use the hex key to remove the screw
3 If necessary, remove the two screws on the back side of the mount
rotate the connector
of the mount.
4 Place the rubber pad around the handlebar:
• If the handlebar diameter is 25.4 mm, use the thicker pad.
• If the handlebar diameter is 31.8 mm, use the thinner pad.
Edge
820
®
from the handlebar connector
1
, and replace the screws to change the orientation
4
EN
.
2
,
3
15