Introduction; Getting Started; Charging The Device; About The Battery - Garmin Edge 1000 Quick Start Manual

Introduction

See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
Always consult your physician before you begin or modify any
exercise program.

Getting Started

When using your device the first time, you should complete
these tasks to set up the device and learn about the basic
features.
Charge the device (Charging the
1
Install your device using the standard mount
2
Standard Mount) or the out-front mount
Front Mount).
Turn on the device (Turning On the
3
Locate satellites (Acquiring Satellite
4
Go for a ride (Going for a
5
Upload your ride to Garmin Connect™
6
Garmin Connect).
7 Register the device (Registering Your

Charging the Device

To prevent corrosion, thoroughly dry the USB port, the weather
cap, and the surrounding area before charging or connecting to
a computer.
The device is powered by a built-in lithium-ion battery that you
can charge using a standard wall outlet or a USB port on your
computer.
NOTE: The device will not charge when outside the
temperature range of 32° to 104°F (0° to 40°C).
1 Pull up the weather cap
Plug the small end of the USB cable into the USB port on the
2
device.
Plug the large end of the USB cable into an AC adapter or a
3
computer USB port.
4 Plug the AC adapter into a standard wall outlet.
When you connect the device to a power source, the device
turns on.
Charge the device completely.
5

About the Battery

This device contains a lithium-ion battery. See the Important
Safety and Product Information guide in the product box for
product warnings and other important information.

Installing the Standard Mount

For the best GPS reception, position the bike mount so the front
of the device is oriented toward the sky. You can install the bike
mount on the stem or the handlebars.
Introduction
WARNING
Device).
(Installing the
(Installing the Out-
Device).
Signals).
Ride).
(Sending Your Ride to
Device).
NOTICE
from the USB port .
WARNING
Select a secure location to mount the device where it does
1
not interfere with the safe operation of your bike.
Place the rubber disk
2
The rubber tabs align with the back of the bike mount so it
stays in place.
Place the bike mount on the bike stem.
3
4 Attach the bike mount securely using the two bands
5 Align the tabs on the back of the device with the bike mount
notches .
Press down slightly and turn the device clockwise until it
6
locks into place.

Installing the Out-Front Mount

Select a secure location to mount the Edge device where it
1
does not interfere with the safe operation of your bike.
Use the hex key to remove the screw
2
connector .
If necessary, remove the two screws on the back side of the
3
mount , rotate the connector
change the orientation of the mount.
Place the rubber pad around the handlebar:
4
• If the handlebar diameter is 25.4 mm, use the thicker pad.
• If the handlebar diameter is 31.8 mm, use the thinner pad.
5 Place the handlebar connector around the rubber pad.
6 Replace and tighten the screw.
NOTE: Garmin ® recommends a torque specification of 7 lbf-
in. (0.8 N-m). You should check the tightness of the screw
periodically.
Align the tabs on the back of the Edge device with the bike
7
mount notches .
on the back of the bike mount.
from the handlebar
, and replace the screws to
.
1