Video Output Connector [N] Cec Mode; Video Output Connector [N] Overscanlevel; Video Output Connector [N] Resolution; Video Output Connector [N] Rgbquantizationrange - Cisco TelePresence SX10 Quick Set Administrator's Manual

Cisco TelePresence SX10 Quick Set

Introduction

Video Output Connector [n] CEC Mode

n: 1..1
This video output (HDMI) supports Consumer Electronics Control (CEC).
When this setting is On, the video conferencing device will use CEC to set the screen in
standby when the device itself enters standby. Likewise the device will wake up the screen
when the device itself wakes up from standby.
Note that the different manufacturers uses different marketing names for CEC, for example
Anynet+ (Samsung); Aquos Link (Sharp); BRAVIA Sync (Sony); HDMI-CEC (Hitachi); Kuro
Link (Pioneer); CE-Link and Regza Link (Toshiba); RIHD (Onkyo); HDAVI Control, EZ-Sync,
VIERA Link (Panasonic); EasyLink (Philips); and NetCommand for HDMI (Mitsubishi).
Requires user role: ADMIN, INTEGRATOR
Default value: On
Value space: Off/On
Off: CEC is disabled.
On: CEC is enabled.

Video Output Connector [n] OverscanLevel

n: 1..1
Some monitors may not present the entire image that they receive. This means that the
outer parts of the image that is sent from the device may be cut off when displayed on the
monitor.
Use this setting to instruct the device not to use the outer part of the available frame. This
part might be cut off by the monitor. Both the video and messages on screen will be scaled
in this case.
Requires user role: ADMIN
Default value: None
Value space: None/Medium/High
None: The device will use all of the output resolution.
Medium: The device will not use the outer 3% of the output resolution.
High: The device will not use the outer 6% of the output resolution.
D15330.16 SX10 Administrator Guide CE9.9, OCTOBER 2019.
Configuration Peripherals Maintenance

Video Output Connector [n] Resolution

n: 1..1
Define the resolution and refresh rate for the connected screen. This value is fixed and
cannot be changed.
Default value: Connector n: Auto
Value space: Connector n: Auto
Auto: The device will automatically try to set the optimal resolution based on negotiation
with the connected monitor.

Video Output Connector [n] RGBQuantizationRange

n: 1..1
Devices connected to an HDMI output should follow the rules for RGB video quantization
range defined in CEA-861. Unfortunately some devices do not follow the standard and this
configuration may be used to override the settings to get a perfect image with any display.
Most HDMI displays expects full quantization range.
Requires user role: ADMIN, INTEGRATOR
Default value: Full
Value space: Auto/Full/Limited
Auto: RGB quantization range is automatically selected based on the RGB Quantization
Range bits (Q0, Q1) in the AVI infoframe. If no AVI infoframe is available, RGB quantization
range is selected based on video format according to CEA-861-E.
Full: Full quantization range. The R, G, B quantization range includes all code values (0 -
255). This is defined in CEA-861-E.
Limited: Limited Quantization Range. R, G, B quantization range that excludes some code
values at the extremes (16 - 235). This is defined in CEA-861-E.
www.cisco.com — Copyright © 2019 Cisco Systems, Inc. All rights reserved.
173
Administrator Guide
Device settings Device settings Appendices