Danfoss VLT HVAC Basic Drive FC 101 Programming Manual page 52

Parameters
6-72 Terminal 45 Digital Output
Option:
3 3
[0] No operation
*
[1] Control Ready
[2] Drive ready
[3] Drive ready/remote control
[4] Standby / no warning
[5] Drive running
[6] Running / no warning
[7] Run in range/no warning
[8] Run on ref/no warning
[9] Alarm
[10] Alarm or warning
[12] Out of current range
[13] Below current, low
[14] Above current, high
[16] Below speed, low
[17] Above speed, high
[19] Below feedback, low
[20] Above feedback, high
[21] Thermal warning
[22] Ready, no thermal warning
[23] Remote, ready, no thermal warning
[24] Ready, Voltage OK
[25] Reverse
[26] Bus OK
[35] External Interlock
[36] Control word bit 11
[37] Control word bit 12
[41] Below reference, low
[42] Above ref, high
[45] Bus Control
[60] Comparator 0
[61] Comparator 1
[62] Comparator 2
[63] Comparator 3
[64] Comparator 4
[65] Comparator 5
[70] Logic rule 0
[71] Logic rule 1
[72] Logic rule 2
[73] Logic rule 3
[74] Logic rule 4
[75] Logic rule 5
[80] SL digital output A
[81] SL digital output B
50
®
VLT HVAC Basic Drive FC 101 Programming Guide
6-72 Terminal 45 Digital Output
Function: Option:
Select the function of [82]
Terminal 45 as a
[83]
digital current output.
[160] No alarm
See also 6-70 Terminal
[161] Running reverse
45 Mode. See
[165] Local ref. active
5-40 Function Relay for
[166] Remote ref. active
description of the
[167] Start command activ
choices.
[168] Drive in hand mode
[169] Drive in auto mode
[193] Sleep Mode
[194] Broken Belt Function
[196] Fire Mode
[198] Drive Bypass
6-73 Terminal 45 Output Min Scale
Range:
0 %
0.0%
6-74 Terminal 45 Output Max Scale
Range:
100 %
100.0%
6-76 Terminal 45 Output Bus Control
Range:
0
*
MG18B302 - Rev. 2013-09-02
SL digital output C
SL digital output D
Function:
[0 - 200 %] Scale for the minimum output (0 or 4 mA)
*
of the analogue signal at Terminal 45. Set
the value to be the percentage of the full
range of the variable selected in
6-71 Terminal 45 Analog Output.
[0.0-200.0%]
*
Function:
[0 - 200 %] Scale for the maximum output (20 mA)
*
of the analog signal at Terminal 45. Set
the value to be the percentage of the
full range of the variable selected in
6-71 Terminal 45 Analog Output.
Current
(mA)
20
0/4
0% Analogue
output
Min Scale
par. 6-73
Illustration 3.11 Output Max Scale
*
[0.0-200.0%]
[0 - 16384 ]
Function:
Analogue Variable
100%
Output for
Max Scale output
par. 6-74 example:
Power
Function: