3 • Basic Operation
Adjusting
the Envelope
Openers
(continued)
3-22
Figure 3.9.5: Inner Envelope Openers Inserted into Envelope
4. Tighten the knob for the adjusted insertion edge.
5. Repeat steps #2 - 4 for the other two insertion edges.
Verify Settings
When you finish making the necessary envelope opener adjustments, close
the insertion area cover, then verify your settings by doing the following:
1. Press CLEAR DECK.
2. Press TRIAL PIECE.
•
If the envelope openers are positioned correctly (aligned correctly to
open the envelope), select OK
•
If more adjustments are needed, repeat the steps stated in the
previous sections until proper alignment is achieved.
NOTE: Each time TRIAL PIECE is pressed, a trial piece is generated.
Adjusting Manual Lever for Stiff Media Mode (Relay 8000 Only)
Mail pieces with stiff inserts leave the machine through the flats exit. The
Stiff Media feature requires manual lever (with sensor) to hold the flats gate
open. This hardware is included with Relay 8000 inserters.
Once one or more inserts have been designated "stiff", the job requires an
envelope of length 6 inches (152 mm) to 7 inches (178 mm) and the manual
lever placed in the flats position.
•
Envelopes must be fed from feeder tower; the HCEF cannot be used.
•
Mail piece components may be too short to leave the inserter through
the flats exit when they are not in an envelope, CLEAR DECK does not
function in stiff media mode. You must clear the inserter manually.
To adjust the manual lever for stiff media mode:
1. Open the sealer cover.
2. Adjust the lever to the stiff media position.
3. Close the sealer cover.
Insertion Edges of Inner
Envelope Openers
SV63136 Rev. A