Pitney Bowes Relay 5000 Operator's Manual page 55

Loading Material
into the Trays
(continued)
SV63136 Rev. A
Loading a Sheet Tray
NOTE: To view a demo of the sheet tray loading and side guide adjustment
processes: go to the Home screen and select "Loading Instructions and Pre-Run
Adjustments". Use the UP/DOWN arrow keys to select a Sheet (being fed by the
Feeder Tower) from the Mail Piece Icon Tree, then select "Feeders Setup Demo".
To load media into a sheet tray:
1. Using the side guide adjustor, open the sides of the tray wide enough to
clear the width of the material.
2. Fan a small stack of material and then place it into the tray, in the
orientation specified in the loading instructions on the Home screen.
Home
Run Trial Piece
Job Items
Home Screen
3. Using the side guide adjustor,, move the side guides in until they lightly
touch the material on both sides.
When you release the adjustor, the guides will automatically spring back
to a position that will allow for proper clearance during feeding of the
material in the tray.
NOTE: Side guides only spring back after they are moved inward.
4. Lift the separator and load material into the tray.
NOTE: Do not load material above the maximum fill line in the tray.
For more information on side guide adjustments, see Adjusting Tray Side
Guides in this chapter.
Basic Operation • 3
Select Another Job
A
SwiftStart
B
Loading Instructions and
D
Pre-Run Adjustments
Pieces :1658
Job: ABC
Low Sealant
Menu
3-11