Pitney Bowes Relay 5000 Operator's Manual page 170

8 • Scanning
Assigning
a Scan
Configuration
to an Existing
Job (continued)
8-24
Menu Option Associated Options/Actions
Mark Location Allows you to setup various OMR mark-related
Settings measurements:
NOTE: This option is •
disabled when Content
in Line with Marks is
•
set to "No" and the
Scan Configuration
•
contains multi-mark
with fixed first and last
mark. •
Follow the steps below to enter the various mark-related
measurements:
a.
b.
c.
NOTE: For more information about determining each of the
above measurements, refer to OMR Specifications in this
chapter.
Item Over Count Allows you to select the number of items that cannot be run
Quantity normally.
a.
b.
NOTE: At this time, only a single scanned insert can be
added to each mail piece. The scanned insert must be a
Reply Envelope (BRE).
Item Over Count Allows you to select what will happen to items that exceed
Action the item over count quantity. Choices include:
•
•
•
Refer to Scanning Features in this chapter for more
information on dynamic envelope selection and divert sheet
functionality.
Top of Page to First Mark is the distance from the top of
the page to the first mark.
Total Length of Marks is the length from the top of the
first possible mark to the bottom of the last mark.
Top of Page to Clear Zone is distance from the top of the
page to the beginning of the Clear Zone.
Length of Clear Zone is the distance from the top of the
Clear Zone to the first mark.
Select an option, then use the UP/DOWN arrow keys to
enter the appropriate measurement (in millimeters).
Press Accept when you are done entering the
measurement.
Once all measurements have been entered, select
Accept to return to the Scan Settings screen.
Use the UP/DOWN arrow keys to enter the item over
count quantity.
Select Accept when you are done.
Divert – Select this option if the scan configuration does
not have the Divert Sheet (DVS) scan mark, and you
want the system to divert items once the item over count
quantity has been exceeded.
Stop - Select this option if you want the system to stop
processing items once the item over count quantity has
been exceeded.
Use Alternate Envelope – Select this option if the Scan
Configuration does not have the Envelope Select (ES)
scan mark, and you want the system to use an alternate
envelope for items that exceed the item overcount
quantity.
SV63136 Rev. A